1. CANCELLATION AND RETURN POLICY: Once an order has
been placed for a manufactured item, it cannot be cancelled.
All panel orders and special order (non-stock) trim
are considered the property of the customer and are
non-refundable once they have been manufactured. All
goods are sold "as is". Standard trim and accessories
are refundable as long as they are returned in a clean,
re-saleable condition. Restocking charges may apply.
ORDERS: Purchaser assumes all responsibility for verbal
All pricing is subject to change without notice.
TAX: All orders are subject to sales tax unless a current
sales tax exemption certificate is provided prior to
TERMS: All orders must be paid in full before they will
-Credit terms may be established at the sole discretion
of the financial department of Baker Metal Works &
-Baker Metal Works & Supply reserves the right to
deny credit without explanation.
-There will be a service charge for all returned checks.
ACCURACY: Purchaser assumes all responsibility for accuracy
of order. All cut lengths and quantities are to be provided
by purchaser and not based on comments or suggestions
of any employee or representative of Baker Metal Works
AND CUSTOMER RESPONSIBILITIES:
A) This contract shall be governed by and construed
in accordance with the laws of the state of Florida.
B) Purchaser assumes all responsibility for applying
city, county and state codes and guidelines applicable
to work performed.
C) Customer is responsible for providing dunage (lumber)
and securing their own load at pick-up.
Uniform visual appearance (color, spangle, shadow spots
and striping) of acrylic-coated galvalume panels cannot
be guaranteed. Non-uniform surface appearance (color,
spangle, shadow spots and striping) may occur over time.
It does not represent a deficiency in the material,
nor does it affect any warranties which may be in place,
and it is not a reason for rejection. (CLICK
HERE to print out our Galvalume terms. *You will
YOU SHOULD KNOW:
-Direct contact with pressure-treated lumber and metal
roofing should be avoided to prevent potential corrosion.
-Damage will result if uninstalled panels or trim are
allowed to remain wet in storage. Be sure to store material
that will not be installed immediately in a dry location.
Wet material should be air-dried and re-stacked when
installation is not planned right away.
-Nibblers, especially carborandum blades on electric
saws, do have a tendency to either leave hot metal particles
that can burn paint surfaces or leave rust marks on
panels and trim. The same is true of any filings left
on the roof caused by the application of screws. Care
should be taken to brush all such particles from roof
surfaces after application. Caution!!! Clean all metal
shavings and particles off of roof to avoid unsightly
-Metal roof panels and trim should not be cut on the